Masport Piccolo Installation Instructions Manual page 19

LOCATING YOUR GAS FIRE
1) When selecting a location for your fire, ensure that the clearances outlined on this page are met.
2) Provide adequate clearances for servicing.
3) The appliance must be installed on a flat, solid, continuous surface (e.g. wood, metal, concrete). This may be the floor,
or raised up on a platform to enhance its visual impact. If the appliance is going to be installed on carpeting, combustible
linoleum tile or other combustible material other than wood flooring, the appliance must be installed on a metal or wood
panel extending the full width and depth of the appliance.
4) The Grenada/Calais Co Axial Flue Gas Fireplace can be installed in a recessed position or framed out into the room
as in A, B, C, D. See Diagram 1.
Diagram 1
A) Flat on Wall
B) Flat on Wall Corner
C) Recessed into Wall/Alcove
D) Corner
5) This appliance is lsted for bedroom installations when used with a listed millivolt thermostat. Some areas may have
further requirements, check local codes before installation.
6) The Grenada/Calais Co Axial Flue Gas Fireplace is approved for alcove installations, which meet the clearances listed
on this page.
7) We recommend that you plan your installation on paper using exact measurements for clearances and floor protection
before actually installing this appliance. Have an authorized inspector, dealer, or installer review your plans before
installation.
MANTEL LEG CLEARANCES
Combustible mantel leg clearances as per diagram below:
Grenada/
Calais
Maximum
38mm
projection at
51mm
minimum
clearance.
Page 19