Wlan Radio Antenna Connection - Motorola MW810 Installation Manual

30 MW810 Mobile Workstation Vehicle Installation Manual
Mini-UHF Connection
To ensure a secure connection of an antenna cable's mini-UHF plug to a MW810 mini-UHF
jack, their interlocking features must be properly engaged. If they are not properly engaged,
the plug will come loose. Using a tool (pliers or wrench) will not overcome a poor
engagement, and is not recommended.
Important Note:
panel of the CPU box. If two W-WAN antennas are used, connect the antennas to the MAIN
and AUX connectors.
The mini-UHF connector tool (Motorola part number HLN6695) is designed to securely
tighten the antenna plug–radio jack connection without damaging either the plug or the jack
(see
Figure 25
Figure 25
Mini-UHF Connector Tool

WLAN Radio Antenna Connection

Connect the cable connector (reversed SMA) of the vehicle RF antenna, if internal Wireless
Local Area Network (WLAN) radio is installed.
For best 802.11b/g communication performance, connect two antennas to AUX and
MAIN W-LAN connectors. For best 802.11n communication performance, connect
three antennas to all W-LAN connectors.
For installation guidelines, See "WWAN Antenna Connection" on page 29.
Recommended antenna: Maxrad Z1961, WLAN Low Profile Mobile Antenna.
Always connect the WWAN antenna to the MAIN connector at the back
Applying excessive force with a tool can cause damage to the antenna
or the connector (e.g., stripping threads, deforming the collar or
connector, or causing the connector to twist in the housing opening and
break).
Note
)
.
mini-UHF connector tool - HLN6695
1. When only one WLAN antenna is installed, connect the antenna
cable to the WLAN connector marked "MAIN" on the back panel of the
CPU Box.
Note
2. The AUX2 WLAN connector type is reverse polarity SMA. To secure
the connector, turn counterclockwise. To release the connector, turn
clockwise.
Squeeze firmly together