Table of Contents
Advertisement
18
MW810 Mobile Workstation Vehicle Installation Manual
To mount the DIN sleeve inside the radio slot, perform the following steps:
Step 1. Remove the radio (if exists) from radio slot in the vehicles dash.
Step 2. Route the display signal cable and the power cable through the radio slot in the
vehicles dash.
Step 3. Slide the DIN sleeve into the slot in the vehicle dash and route the display signal
cable and the power cable through the sleeve.
Step 4. When the sleeve is fully inserted and the front edge or lip is seated, secure the sleeve
to the radio slot by bending the tabs on the sleeve behind the plastic of the dash.
Figure 14
8.4" Display - Installation of DIN Sleeve
The DIN mount can only be adjusted during installation and may
require reinstallation before the final position is determined. No end-
user adjustment is available.
Note
The following installation steps may change according to your specific
vehicle model and application requirements.
Back Anchor Holes
Bottom Anchor Holes
DIN Mount Sleeve
!
To ensure maximum safety, the DIN sleeve must be fastened to the
vehicle using the back, and/or side and bottom anchor holes.
Warning
Tabs
Radio (DIN) Slot
Side Anchor Holes
Advertisement
Table of Contents
