To Assumable and Install the Display DIN Mount, perform the following steps (see Figure
15):
Step 1. Position the left-hand side and right-hand side Arm Brackets inside the DIN Sleeve.
Use the holds on the arms to determine the distance of the display from the dash, and
fasten the arms using four nuts to inner studs.
Arm Bracket
Tilt Bracket
Swivel Bracket
Figure 15
8.4" Display - DIN Mount Breakdown
Note
Step 2. Use four screws to connect the left-hand side and right-hand side Arm Brackets to the
Tilt Bracket. Pivot the Tilt Bracket up/down to determine the display tilt position and
secure the four screws.
Step 3. Route the display signal cable and the power cable through the opening in the Tilt
Bracket.
Step 4. Use four screws to connect the Swivel Bracket to the Display Bracket. Use the line of
holes on the Display Bracket enable to determine the display height position and
connect the display using four screws.
DIN Mount Sleeve
Swivel Plate
Display Bracket
Vehicle vibrations may loosen the mount parts. It is very
important to use the spring washers when assembling the
display mount.
Installation
19
Arm Bracket