Motorola MW810 Installation Manual page 31

Step 9. Assemble the Swivel Bracket (connected to the VESA plate) to the Tilt Bracket. The
Swivel Bracket determines the pivot position of the display.
Step 10. Use the center screw slot on the Swivel Bracket to align the display and set the
swivel angle, then fasten using the two side screws and Swivel Plate.
Connection to Standard Personal Computer
The Laptop to MW810, 8.4" Display Signal Cable (optional DVI, p/n FKN8547 or RGB, p/n
FKN8546 cable) enables you to interface the MW810, 8.4" Display to any laptop or personal
computer. For cable connection, refer to Figure 17.
Standard Laptop or Personal Computer
RGB or DVI Connector
USB Connector
(male type)
Speaker Jack
Figure 17
Connection of MW810, 8.4" Display to Laptop or Standard Personal Computer
The following table describes the connectors of the MW810, 8.4" Display to Laptop or
Standard Personal Computer.
Connector
RGB or DVI
USB 2.0
Speaker Jack
On /Off Signal
Wire
(Green wire)
On /Off Signal Wire (Green wire)
Description
RGB or DVI signals from the personal computer to display.
USB communication with the personal computer.
This communication enables operation of the function buttons,
emergency button and Power button for turning the workstation
On/Off.
Audio signal from the personal computer to display speaker.
On /Off Signal Wire (active low 0V) is used as a trigger signal for
activating the display when docking the ML910 or ML900 laptop
computers.
Installation
Optional Left Exit Cable
Laptop to MW810, 8.4" Display Signal Cable
21