Table of Contents
Advertisement
• Do not locate cables where they can be kicked by the driver or passengers or where they
can interfere with operation of the driver's foot pedals.
• When routing the cable, refrain from creating sharp bends or kinks.
• Cables longer than 10 ft. (3.05 m) should be routed through special UL listed conduit/duct
for electrical cables. This conduit/duct should fully enclose the cable along its whole
length.
12.1" Display
The 12.1 display is attached to the display mount by Phillips screws (M4), supplied in the
display shipping package. The CPU to Display Signal Cable is routed from the CPU Box,
through the mount, and connected to the lower back side of the display (see Figure 8).
Form a service loop for the Power and Display Signal Cables to reduce cable tension. Use
plastic cable ties to secure the cables to cable tie points
Use caution when connecting the display to CPU cable. Rough
!
installation may damage the connectors/receptacles of the display,
cable or CPU Box.
Caution
Installation
11
Advertisement
Table of Contents
