Table of Contents
Advertisement
20
MW810 Mobile Workstation Vehicle Installation Manual
Step 5. Plug the connector of the display signal cable and use the three screws to secure the
connector to the display.
Step 6.
N
left-side driver seat position.
Step 7. Plug the keyboard cable to the USB port and secure the cable to the display by using
the thumb screws.
Step 8. Plug the power cable to the power connector on the back of the display.
Swivel Bracket
Use Cable Clamp
USB 2.0
Port for
Temporary
Connection
of Devices
Figure 16
8.4" Display - Installation of Cables
ote that cables are available with right-side or left-side display exit for right-side or
Use caution when connecting the display to CPU cable. Rough
!
installation may damage the connectors/receptacles of the display,
cable or CPU Box.
Caution
!
To avoid damage to the display and CPU Box, verify that the Main
Power switch, located on the back panel of the CPU Box, is turned Off
Caution
before connecting cables to the display.
The maximum current load from USB 2.0 port is 500mA.
Use the rubber plug, provided with this product, to seal the port when
Note
not in use.
Center Screw Hole
USB 2.0 Port
for keyboard
The display is powered directly from the vehicle power system. The
display software uses power management tools to prevent excessive
battery drainage during normal operation and vehicle start.
Note
Center Screw
VESA Plate
Power Connector
Power Cable
Display Signal Cable
15A SB Fuse
Keyboard Cable to USB 2.0 Port
Side Screws
Advertisement
Table of Contents
