Table of Contents
Advertisement
6.Setup
6.1 DIP Switches Settings of Door Station
Total 2 bits on the DIP switches can be configured.The switches can be modified either before or after
installation.
Bit state
ON
1 2
ON
1 2
ON
1 2
ON
1 2
6.2 DIP Switches Settings of Monitor
There are 6 bit switches in total. The DIP switches are used to configure the User Code for each Moni-
tor.
Bit-6 is used to set video impedance,it should be set to ON if the Monitor is in the end of the line(bus),
otherwise set to OFF.
ON(1)
O N
=
Default setting, ID = 0(00), set to the first Door Station.
ID = 1(10), set to the second Door Station.
ID = 2(01), set to the third Door Station.
ID = 3(11), set to the fourth Door Station.
Bit state
Setting
The monitor is
ON
not at the end
1 2 3 4 5
6
of the bus.
OFF(0)
O N
=
Descriptions
Bit state
ON
1 2 3 4 5
6
Setting
The monitor
is at the end
of the bus.
-9-
Advertisement
Table of Contents
