Canon MultiPASS C530 Service Manual page 190

#3 NUMERIC Param.
(Numeric parameter settings)
Default
01: 0
02: 10 (10%)
03: 15 (15 lines)
04: 12 (12 times)
05: 4
06: 4
07: 0
08: 0
09: 6 (6 digits)
10: 5500 (55 seconds)
11: 3500 (35 seconds)
12: 0
13: 1320 (13 seconds)
14: 0
15: 120 (1200 ms)
16: 4 (4 seconds)
17: 100 (1000 ms)
18: 0 (0 ms)
19: 200 (2000 ms)
20: 100 (1000 ms)
21: 0 (0ms)
22: 200 (2000 ms)
23: 8 (MultiPASS C530)
44(MultiPASS C560)
24: 20
25: 60 (600 ms)
26: 4 (MultiPASS C530)
44(MultiPASS C560)
27: 0
28:
0
29: 0
30: 0
Figure 3-14 Service Data (page 3)
No. 01, 05 to 08, 12, 14, and 27 to 30 are not used. Do not change their settings.
MultiPASS C530/C560 Chapter 3: Maintenance & Service
Range
Not used
(1~99) RTN signal transmission condition (1)
(2~99) RTN signal transmission condition (2)
(1~99) RTN signal transmission condition (3)
Not used
Not used
Not used
Not used
(1~20) The number of digits in telephone number
compared against TSI signal to be matched
for restricted receiving function
(0~9999) Line connection detection time (T0 timer)
(0~9999) T1 Timer (Rx)
Not used
(0~9999) Maximum time to receive oneline of image data
Not used
(0~999) Hooking detection time
(0~9) Pseudo RBT transmission from CML on time
until start
(0~999) Pseudo RBT signal pattern: On time
(0~999) Pseudo RBT signal pattern: Off time (short)
(0~999) Pseudo RBT signal pattern: Off time (long)
(0~999) Pseudo ring pattern: On time setting
(0~999) Pseudo ring pattern: Off time (short)
(0~999) Pseudo ring pattern: Off time (long)
(0~9) FAX/TEL switching function (MultiPASS C530 only)
(Do not change) signal detection level
(0~20) Pseudo-RBT signal transmission level
(0~999) Answering machine connection function
signal detection time
(0~9) Answering machine connection function (MultiPASS C530 only)
(Do not change) no sound detection level
Not used
Not used
Not used
Not used
3-33