New Sssws/Parameters Added To This Model - Canon MultiPASS C530 Service Manual

5.2.5 New SSSWs/parameters added to this model

#1 SSSW (service soft switch setting)
SW01 (service soft switch 01: error management)
Bit Function
0 Service error code
1 Error dump list
2 Not used
3 Copy function
4 (New) ##300 series service error code
5 Not used
6 Not used
7 User setting restriction
[Bit 4]
Even when Bit0 is set to "Not output", you can select whether or not to output ##300 series Service
Error Codes, caused by hardware malfunction.
When "Output" is selected, ##300 series Service Error Codes are displayed and in reports.
When "Not Output" is selected, no Service Error Codes are displayed.
SW28 (service soft switch 28: V.8/ V.34 protocol settings)
Bit Function
0 (New) Caller V.8 protocol
1 (New) Called party V.8 protocol
2 (New) Caller V.8 protocol late start
3 (New) Called party V.8 protocol late start NO
4 (New) V.34 reception fallback
5 Not used
6 Not used
7 Not used
[Bit 0]
Select whether to use the V.8 protocol when calling. If NO is selected, the V.8 protocol is inhibited
at calling and the V.21 protocol is used.
[Bit 1]
Select whether to use the V.8 protocol when called. If NO is selected, the V8 protocol is inhibited
when called and the V.21 protocol is used.
[Bit 2]
If ANSam signal is not received during transmission (mainly manual transmission), select whether
to use the V.8 protocol when the other fax machine declares the V.8 protocol in DIS signal. If NO
is selected, the CI signal is not transmitted and the V.8 protocol is not used even if the DIS that
specifies the V.8 protocol is received.
MultiPASS C530/C560 Chapter 3: Maintenance & Service
1
Output
Output
No
Output
Setting possible
1
NO
NO
NO
Prohibited
3-39
0
Not output
Not output
Yes
Not output
Setting restricted
0
YES
YES
YES
YES
Not prohibited