Canon MultiPASS C530 Service Manual page 132

b) In the model template, the combination (10-bit pixel pattern) of 10 pixels is output to the arithmetic
encoding section using the template shown below (inside the bold outline).
All of the 10-bit pixel patterns inside this template exist in the study table. This 10-bit pixel pattern is
used by the arithmetic encoding section to refer to the predicted value of the pixel and the status
number in the study table which correspond to the 10-bit pixel pattern.
X
3-line model template
There are two types of model templates ~ 3-line and 2-line, and the one selected is
designated by the LRLTWO inside the Bi-level Image Header section (BIH). The pixel
shown by "X" is an encoded pixel and is outside of the template.
NOTE
The pixel shown by "AT" is a special pixel known as an AT pixel. The AT pixel becomes
a Adaptive Template by having its position moved, and is very effective when encoding a
periodic pixel, similar to a dither pattern image.
The position of AT in the figure is the beginning position of the AT pixel.
In this fax, it remains fixed in this initial position, so Adaptive Template is not used.
c) The study table, as shown below, is constructed by all of the 10-bit pixel patterns output by the model
template, and their corresponding status numbers and predicted values of the pixel to be encoded.
The predicted value of the pixel to be encoded and the status number is compared to the actual pixel in
the arithmetic encoding section every time the model template is moved to the adjoining pixel.
The result of this comparison (matches / does not match predicted value) and the status number are
then checked by comparison to the probability estimation table, and the study table is corrected
(learned) to a new prediction value and status number which will be used when the same pixel pattern
is found again.
By learning in this way, the probability of the study table matching the next time is increased, and the
need for encoding decreased.
MultiPASS C530/C560 Chapter 2: Technical Reference
AT
Figure 2-33 Model Templates
2-53
X
2-line model template
AT