Canon MultiPASS C530 Service Manual page 169

MultiPASS C530/C560 Chapter 3: Maintenance & Service
"CARTRIDGE JAMMED"
Printing position correction failed
Cause:
Countermeasure:
Cause:
Countermeasure:
Home position error
Cause:
Countermeasure:
Cause:
Countermeasure:
Cause:
Countermeasure:
Cause:
Countermeasure:
Cause:
Countermeasure:
NOTE
Carriage movement prevented by one of the following.
Damaged shaft.
Parts deformed. (Carriage or guide frame)
Insufficient grease.
Replace the shaft.
Replace the deformed parts.
Apply more grease.
Bi-directional print displacement correction failed because the carriage motor
is out of step, or some similar reason.
Replace the carriage motor.
Foreign body in carriage section.
Open printer cover, and remove foreign body.
Loose carriage belt.
Replace carriage belt.
Guide frame home position detection tabs is damaged or bent parts.
Replace the damaged or bent parts.
Carriage motor does not work.
(1) Switch power OFF/ON.
(2) Replace carriage motor.
Carriage position cannot be detected. (Home position sensor breakdown, or BJ
controller malfunction)
(1) Switch power OFF/ON.
(2) Replace carriage cable with one that has a home position sensor attached.
(3) Replace the SPCNT board.
This error message means the same as service error codes ##338 and ##340. When this
error occurs in this model, it is not treated as a service error, but as a user error, and the
error message is displayed.
3-12