Canon MultiPASS C530 Service Manual page 176

Hide thumbs Also See for MultiPASS C530:
Table of Contents

Advertisement

No.
Tx or Rx
##283
[ TX
##284
[ TX
##285
[ TX
##286
[ TX
##287
[ TX
##288
[ TX
##289
[ TX
##290
[ TX
• Printer error codes
No.
Tx or Rx
##332
[TX/RX ]
##333
[TX/RX ]
##334
[TX/RX ]
##335
[TX/RX ]
##336
[TX/RX ]
##337
[RX
new
##342
[TX/RX ]
##345
[TX/RX ]
##346
[TX/RX ]
##348
[TX/RX ]
• V.8/V.34 protocol error codes (MultiPASS C560 only)
No.
Tx or Rx
##670
[ TX
##671
[ RX
##672
[ TX
##673
[ RX
##674
[ TX
##675
[ RX
MultiPASS C530/C560 Chapter 3: Maintenance & Service
Definition
]
Excessive repeat protocol during Tx
]
DCN reception after TCF transmission
]
DCN reception after EOP transmission
]
DCN reception after EOM transmission
]
DCN reception after MPS transmission
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after EOP
transmission
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after EOM
transmission
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after MPS
transmission
Definition
Printer control DRAM check error
Printer control ROM check error
Printer control EEPROM check error
Data transmission error between the system control section and printer
control section
BJ head abnormal temperature error
]
BJ head temperature sensor error
Cleaning absorption waste ink capacity full
BJ cartridge head cleaning error
Inside temperature error
Ink detection sensor error
Definition
]
At V.8 late start, the called party declares the V.8 protocol in DIS
signal and this unit transmits a CI signal, but the protocol does not
progress and a T1 time-out occurs.
]
At V.8 termination, the protocol did not advance to phase 2 and a T1
time-out occurs after the caller CM signal was detected.
]
The protocol did not move from phase 2 to phase 3 and a T1 time-out
occurred during V.34 transmission.
]
The protocol did not move from phase 2 to phase 3 and a T1 time-out
occurred during V.34 reception.
]
The protocol did not move from phase 3 to phase 4 and a T1 time-out
occurred during V.34 transmission.
]
The protocol did not move from phase 3 to phase 4 and a T1 time-out
occurred during V.34 reception.
3-19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multipass c545Multipass c560Multipass c555Fp b740

Table of Contents