Konica Minolta BIZHUB C20 User Manual page 197

1
With the main screen (Scan mode) or
played, press the AddressBook key four times so that
appears.
2
Press the + or , key to select
Select key.
3
Press the + or , key to select
Select key.
To search registered names, select
addresses, select
4
Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword,
onds.
For details on entering/editing text, refer to "Entering Text" on page
323.
Text starting with the first character of the maximum 10 characters
is searched for. Text will not be found if the search keyword is in
the middle of a word.
5
Press the + or , key to select the desired data, and then press the Select
key.
To check the found information, press the ) key.
An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified,
appears for about two seconds, and then the screen for specifying
the destination address appears.
To narrow down the search results, press the Back key, and then
perform step 4 again.
6
Press the Select key again.
7
Press the + or , key to select
To add an additional e-mail address, select
then specify the destination. To edit the specified e-mail address,
select
"Editing a Specified Destination Address". To delete a specified
e-mail address, select
with step 2 of "Deleting a Specified Destination Address". The
address cannot be edited.
Scanning With the Machine
LDAP SEARCH
NAME
E-MAIL
NOT FOUND
FINISH
in step 7, and then continue with step 2 of
CHECK/EDIT
CHECK/EDIT
Can Use AddressBook
, and then press the
or , and then press the
E-MAIL
. To search e-mail
NAME
.
appears for about two sec-
ADDRESS IS TOO LONG
, and then press the Select key.
ADD
in step 7, and then continue
dis-
PHONE BOOK
in step 7, and
183