Searching An Ldap Server - Konica Minolta BIZHUB C20 User Manual

3
Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword,
onds.
For details on entering/editing text, refer to "Entering Text" on page
323.
Text starting with the first character of the maximum 10 characters
is searched for. Text will not be found if the search keyword is in
the middle of a word.
4
Press the + or , key to select the desired data, and then press the Select
key.
To narrow down the search results, press the Back key, and then
perform step 3 again.
5
Press the Select key again.
If an FTP address or an SMB address was selected, the destination
address is specified.
6
If an e-mail address was selected, press the + or , key to select
, and then press the Select key.
ISH
To add an additional e-mail address, select
then specify the destination. When sending the data to an FTP
address or SMB address, multiple addresses cannot be specified.
To check the specified e-mail address, select
step 6. To delete an address, select
then continue with step 2 of "Deleting a Specified Destination
Address".

Searching an LDAP Server

The destination e-mail address where the scan data is to be sent can be
specified by using information on the LDAP server.
To connect to an LDAP server, settings for
specified. For details, refer to the Reference Guide on the Documenta-
tion CD/DVD.
A maximum of 16 addresses (total of addresses from direct input and
an LDAP search) can be specified.
If anonymous access is used to search for information on an LDAP
server, the correct search results may not be retrieved.
182
appears for about two sec-
NOT FOUND
CHECK/EDIT
LDAP SETTING
Scanning With the Machine
FIN-
in step 6, and
ADD
in
CHECK/EDIT
in step 6, and
must be