Upper Control Panel - Sony DNW-A100 Operation Manual

2-1 Control Panels

2-1-1 Upper Control Panel

1 POWER
switch
dB dB
0 0
POWER
-10 -10
ON
-20 -20
-30 -30
-40 -40
OFF
-80 -80
PHONES CH-1 CH-2
DISPLAY PULL FOR VARIABLE
FULL/FINE
1 POWER switch
This powers the unit on and off. When the unit is
powered on, the level meters 2 and the fluorescent
display in the lower control panel light.
To power the unit off, press the side of the POWER
switch marked "OFF".
Note
After carrying out operations on this unit using the
hard disk, before powering the unit off be sure to press
the EJECT button (see page 2-17) to close the files on
the hard disk. Powering off the unit with files left
open may result in a loss of system data from the hard
disk.
..........................................................................................................................................................................................................
1) E-E mode: Abbreviation of "Electric-to-Electric mode."
In this mode, video and audio signals input to the VTR
are output after passing through internal electric circuits,
but not through magnetic conversion circuits such as
heads and tapes. This can be used to check input signals
and for adjusting input signal levels.
2-2
Chapter 2 Location and Function of Parts
2 Level meters 4 VIDEO INPUT SELECT switch and indicators
3 REC controls 5 Audio selection function selector switch and indicators
dB dB
0 0
-10 -10
2
-20 -20 0
-2
-30 -30
-40 -40
-4
-80 -80
CH-3 CH-4 VIDEO
REC
VIDEO INPUT SELECT
SDDI (VIDEO&AUDIO)
INPUT
SDI
COMPONENT
PB
MONITOR
(Y-R,B)
COMPOSITE
7 VIDEO control
8 PB controls
9 DISPLAY FULL/FINE switch
0 PHONES jack and control
6 AUDIO INPUT/MONITOR SELECT buttons
(Before Version 2.00)
AUDIO INPUT/MIXING/MONITOR SELECT
buttons (Version 2.00 or later)
Cassette compartment
ANALOG / HIGH SPEED
DIGITAL
AUDIO INPUT/MONITOR SELECT
TC
CH-1 CH-2 CH-3 CH-4 LTC
SDI
AUTO INT
L
ANALOG/ VITC EXT
AES/EBU
R
!¡ Time code setting section
!™ REMOTE/LOCAL switch and indicator
2 Level meters
These show the audio levels of channels 1 to 4
(recording levels in recording mode or E-E mode
playback level in playback mode) and the video levels
of input composite video signals.
There are two modes for audio level indications:
FULL and FINE, selected by the DISPLAY FULL/
FINE switch 9.
TC GENERATOR REMOTE
/LOCAL
VITC
FREE
PRESET DEF ON
RUN
REC
REGEN NDF 9P
RUN
1)
and