Sony DNW-A100 Operation Manual page 22

2-1 Control Panels
4 PLAYER button and RECORDER button
When carrying out editing using a player and recorder,
select each of the devices.
• To select the player: press the PLAYER button,
turning it on. (PLAYER mode)
• To select the recorder: press the RECORDER button,
turning it on. (RECORDER mode)
• To select both the recorder and the player: press the
RECORDER button and the PLAYER button
simultaneously, turning both of them on. ("PARA
RUN" mode)
In this case, extended menu item 201 must already
have been set to PARA RUN ENABLE.
When an external device (EXT) is specified as the
player and if it is not in the remote mode, neither of the
buttons lights. In this case, operations apply to the
device specified as the recorder.
4 Editing control section
1 UNDO button
2 RECALL button
3 DELETE button
UNDO RECALL DELETE
AUDIO
IN
PREVIEW/
AUTO EDIT
REVIEW
IN
8 Edit point setting buttons
9 AUTO EDIT button
0 PREVIEW/REVIEW button
1 UNDO button
Use this in nonlinear editing to undo the effect of the
immediately previous automatic editing operation, and
return to the previous state.
This button lights, and the AUTO EDIT button flashes.
To return to the state before the immediately previous
automatic editing operation, press the AUTO EDIT
button. To cancel the undo operation, press this button
again, turning it off.
2-14
Chapter 2 Location and Function of Parts
4 EVENT button
5 FEED button
EVENT FEED
OUT
OUT ENTRY INDEX
6 INDEX button
7 ENTRY button
2 RECALL button
During playback of a program (DISK PROGRAM) or
when playback is stopped, pressing this button while
holding down the EVENT button recalls the IN and
OUT points of the event being played back, causing
the IN and OUT buttons to light. Use this button when
you wish to modify the IN and OUT points.
3 DELETE button
This deletes an edit point or event.
Hold down this button and press the IN, OUT, AUDIO
IN, AUDIO OUT, or EVENT button according to the
what you wish to delete. If the button (IN, OUT,
AUDIO IN, or AUDIO OUT) which you pressed to
make the deletion flashes, it is necessary to set the
deleted edit point again.
4 EVENT button
Use this button when you wish to save two or more
player editing segments (each segment being between
an edit IN point and OUT point) as an "event", and
carry out automatic editing of all the events together
(multi-event editing).
To save events, after setting each editing segment,
hold down this button and press the ENTRY button.
This is also used for other operations relating to
events.
For details of operations relating to events, see Section 5-3,
"Multi-Event Editing" (page 5-14) and Section 5-4,
"Special Nonlinear Editing Operations" (page 5-17).
5 FEED button (DNW-A100/A100P only)
Use this button when you wish to carry out dubbing
from tape or the hard disk to an external device or
high-speed automatic editing from tape to the hard disk
at any speed from 0.1 to 4 times normal.
To play back in feed mode, hold down this button and
press the PLAY button.
For details of operations in feed mode, see the section
"Carrying out playback in feed mode" (page 4-10) and the
section "Carrying out high-speed editing in feed mode"
(page 5-11).