Sony DNW-A100 Operation Manual page 23

6 INDEX button
Use this in the following cases:
• During playback of a Betacam SX format tape
For cuing up to the point where index information
(good shot marker or recording start marker) is
recorded on a Betacam SX camcorder tape
• During playback from the hard disk
For cuing up to a particular event
For details, see the items for the F FWD button and REW
button (see page 2-17).
7 ENTRY button
Use this for setting edit points, saving events and so
forth.
• To set a video IN point or OUT point: Hold down
the IN button or OUT button, and press this button.
• To set an audio IN point or OUT point: Hold down
the AUDIO IN button or AUDIO OUT button, and
press this button.
• To save an event: Hold down the EVENT button,
and press this button.
For details of operations relating to events, see Section 5-3,
"Multi-Event Editing" (page 5-14) and Section 5-4,
"Special Nonlinear Editing Operations" (page 5-17).
8 Edit point setting buttons
AUDIO
IN OUT
AUDIO IN button and AUDIO
OUT button
IN OUT
IN button and OUT button
IN button and OUT button
To set a video IN point or OUT point, hold down the
IN button or OUT button, and press the ENTRY
button.
After you have made the setting, pressing the IN
button or OUT button displays the IN point or OUT
point set on the fluorescent display.
AUDIO IN button and AUDIO OUT button
In insert editing of the program, to set an audio IN
point or audio OUT point separate from the
corresponding video edit point, hold down the AUDIO
IN button or AUDIO OUT button, and press the
ENTRY button.
After you have made the setting, pressing the AUDIO
IN button or AUDIO OUT button displays the audio
IN point or audio OUT point set on the fluorescent
display.
9 AUTO (automatic) EDIT button
After edit point setting, to carry out automatic editing
(recording), press this button, turning it on.
If the IN point is not set, the automatic editing is
carried out with the point where you pressed this
button as the IN point.
If you pressed the PREVIEW/REVIEW button to carry
out a preview, when the preview ends it flashes.
0 PREVIEW/REVIEW button
After edit point setting, to preview the editing results
on the monitor before recording, press this button,
turning it on.
If the IN point is not set, the preview is carried out
with the point where you pressed this button as the IN
point.
During the preview it is lit, and when the preview ends
it flashes.
Use this button also to carry out a review of the editing
results after carrying out automatic editing.
Chapter 2 Location and Function of Parts
2-15