Sony DNW-A100 Operation Manual page 117

1
Display the disk file management menu, select
item F1, then press the SET button.
The displays shown below appear in the time data
display and on a monitor connected to the
COMPOSITE VIDEO OUTPUT 3 (SUPER)
connector.
Time data display
Monitor
DISK FILE MANAGEMENT
*SIMPLE
2
Holding down the JOG button, turn the search dial
so that the indication in the time data display
changes from "SIMPLE" to "FULL".
Displayed while the JOG button is held down.
3
Release the JOG button to confirm the setting.
The indication in the time data display changes as
follows.
If it is not possible to switch between the full
edit mode and simple edit mode (e.g. if already
recorded program or files are present)
The following message appears in the time data
display.
For information about how to switch between full edit
mode and simple edit mode when this message appears,
see the following item, "Switching between full edit
mode and simple edit mode (when already recorded
program or files are present)."
4
Press the SET button to carry out the switch
between full edit mode and simple edit mode.
The indication in the time data display changes as
follows.
5
Press the MENU button a number of times, to exit
from the disk file management menu.
The indication in the time data display returns to
the state before executing step 1.
Switching between full edit mode and
simple edit mode (when already recorded
program or files are present)
When already recorded program or files are present, it
is not immediately possible to switch between full edit
mode and simple edit mode. In step 3 of the procedure
in the previous item, "Switching between full edit
mode and simple edit mode (F1)", the message "F1-
CANNOT SEL" appears in the time data display. In
this case, to switch between full edit mode and simple
edit mode, carry out either of the following
procedures.
7-27
Chapter 7 Menu System