Removing/Reattaching Lower Control Panel Unit - Sony DVW-M2000 Installation Manual

Hd digital videocassette recorder
Hide thumbs Also See for DVW-M2000:
Table of Contents

Advertisement

1-12. Removing/Reattaching Lower Control Panel Unit

1-12. Removing/Reattaching Lower
Control Panel Unit
The lower control panel unit is detachable from the main
unit, therefore operation with placing the single panel unit
on the table as a keyboard of a personal computer is
possible. (The length of the connected cable is about 62
centimeters.)
Front switch panel
Cable
Lower control panel unit
Not only connecting the cable to a CONTROL PANEL
connector in the front switch panel, but connection be-
tween the cable and the CONTROL PANEL connector in
the rear connector panel provides operating the lower
control panel. After connection, set a PANEL SELECT
switch on the switch panel as follows:
Connector to be connected
to lower control panel unit
Front (on the switch panel)
Rear (on the connector panel)
Settings when connecting the two lower control
units
When connecting the two lower control units to one VTR,
select which operation to enable by setting from the setup
extended menu ITEM-117.
Operation
Setting of ITEM-117
enabled
Front-side panel
SW or PARA
Rear-side panel
SW (Factory setting)
Both panels
PARA
n
To display ITEM-117 for MSW-series, menu display
setting is necessary. See Section 1-10-4. As to the setting
of ITEM-117, refer to the operation manual of the VTR.
1-22
PANEL SELECT switch
Setting of PANEL
SELECT switch
FRONT (Factory setting)
REAR
Setting of PANEL
SELECT switch
FRONT
(Factory setting)
REAR
REAR
MSW-2000/A2000/A2000P/M2000/M2000P/M2000E/M2000EP/M2100/M2100P/M2100E/M2100EP
Removal/Extension of the Lower Control Panel
Unit
1. Turn off the power of VTR.
2. After pressing the unlock button, open the lower
control panel as shown in the figure below.
3. Disconnect the cable from the connector on the back
side of the lower control panel unit and from the cord
holder.
n
Check the power of the VTR is turned off before
disconnecting the cable. Disconnecting or connecting
the cable in the power-on state will damage the control
panel.
4. Remove the two screws shown in the figure.
Unlock button
BVTT3 x 6
Lower control panel unit
Back view
Cable
Cable holder
5. Lightly draw the lower control panel unit toward you,
and then lift it upward.
Lower control panel unit
HDW-2000/M2000/M2000P/S2000/S2000P/M2100/M2100P, DVW-2000/2000P/M2000/M2000P
POWER
O
I
Power OFF
Unlock button
BVTT3 x 6
Connector

Advertisement

Table of Contents
loading

Table of Contents