Upper Control Panel - Sony DSR-2000AP Operating Instructions Manual

Location and Function of Parts

Upper Control Panel

1 POWER switch
2 Audio level meters
POWER
dB dB dB dB dB dB
OVER OVER OVER
0 0 0
2 2 2
-12 1 -12 1 -12 1
0 0 0
-20 -20 -20
-1 -1 -1
-30 -30 -30
-40 -40 -40
-2 -2 -2
1 2 3
-60 -60 -60
1 POWER switch
Press the "1" side to power the unit on. When the unit
is powered on, the display windows in the upper and
lower control panels light.
To power the unit off, press the "¬"side of the switch.
2 Audio level meters
These show the audio levels of channels 1 to 4
(recording levels in recording mode or E-E mode
playback level in playback mode).
1 Input selection/audio mode display section
1 INPUT display
2 INPUT VIDEO display
3 AUDIO CH1, 1/2 display
4 AUDIO CH2, 3/4 display
5 PB FS display
.........................................................................................................................................................................................
1) E-E mode: Abbreviation of "Electric-to-Electric mode".
In this mode, video and audio signals input to the VCR
are output after passing through internal electric circuits,
14
Chapter 1 Overview
1 Input selection/audio mode display section
(see below)
2 Input selection section
(see page 15)
INPUT SELECT
SDTI/i.LINK
dB dB
OVER
INPUT V:SDTI SDTI i.LINK
0
2
VIDEO IN
VIDEO COMPOSITE Y-R,B S VIDEO SDI SG
-12 1
0 CH11/2 CH-1,1/2
-20 ANALOG AES/EBU SDI SG
AUDIO
-1
-30 ANALOG AES/EBU SDI SG
CH23/4
-40 CH-2,3/4
-2
PB FS 48k44.1k32k REC MODE 2CH4CH
4
-60
MIXING
1) and
V:SDTI
INPUT
VIDEO COMPOSITE
CH11/2
ANALOG
AUDIO
ANALOG
CH23/4
PB FS 48k44.1k32k
3 Cassette compartment
There are two modes for audio level indications:
FULL and FINE, selected by the METER FULL/FINE
button on the lower control panel.
3 Cassette compartment
Accepts DVCAM, DV and DVCPRO(25)
videocassettes.
For details of usable cassettes, see page 34.
SDTI i.LINK
SDI SG
Y-R,B S VIDEO
AES/EBU SDI SG
SDI SG
AES/EBU
REC MODE 2CH4CH
but not through magnetic conversion circuits such as
heads and tapes. This can be used to check input signals
and for adjusting input signal levels.
3 Remote control
setting section
(see page 16)
REMOTE
9PIN
i.LINK
6 REC MODE display