Sony DNW-A100 Operation Manual page 119

If it is not possible to convert the file type (e.g.
when the hard disk is busy immediately after
power on)
The following message appears in the time data
display.
In this case, wait until the DISK BUSY indicator
in the lower control panel goes off, then return to
step 2.
4
Press the SET button to carry out the file type
conversion.
The indication in the time data display changes as
follows.
During the file type conversion
When the file type conversion is completed
5
Press the MENU button a number of times, to exit
from the disk file management menu.
The indication in the time data display returns to
the state before executing step 1.
Selecting the editing accuracy (F3)
For a program created in simple edit mode (when F1 is
SIMPLE), use the following procedure to select the
editing accuracy (GOP: ±1 frame; FRAME: ±0
frame).
(Taking switching from GOP to FRAME as an
example)
1
Display the disk file management menu, select
item F3, then press the SET button.
The displays shown below appear in the time data
display and on a monitor connected to the
COMPOSITE VIDEO OUTPUT 3 (SUPER)
connector.
Time data display
Monitor
DISK FILE MANAGEMENT
F3:SELECT GOP/FRAME
*GOP
2
Holding down the JOG button, turn the search dial
so that the indication in the time data display
changes from "GOP" to "FRAME".
Displayed while the JOG button is held down.
3
Release the JOG button to confirm the setting.
The indication in the time data display changes as
follows.
If it is not possible to switch the editing
accuracy (e.g. for a switch from FRAME to
GOP, if an already recorded program is
present)
The following message appears in the time data
display.
(Even if there is an existing program, it is still
possible to switch from GOP to FRAME.)
(Continued)
7-29
Chapter 7 Menu System