Modifying And Deleting Edit Points - Sony DNW-A100 Operation Manual

6-1 Automatic Editing
To display the duration of an edit
You can display the duration between two edit points
in the following three cases, in the device specification
and display section (see page 2-10).
• When both the IN point and OUT point are set: the
duration of the segment between the two points
• When only one of the IN point and OUT point is set:
the duration of the segment between the point
which is set and the current tape position
• When neither of the IN point and OUT point is set:
the duration of the previous editing segment
The duration is displayed across time data display
areas 1 and 2, thus: "DURATION 00:01:10:00".
To display a duration, use the following procedure.
1
Press the RECORDER button or PLAYER button
to select the VTR on which you wish to check the
duration.
The button you have pressed lights.
2
Hold down both the IN button and OUT button.
While you hold down the buttons, the duration is
displayed across time data display areas 1 and 2.
6-4
Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
6-1-4 Modifying and Deleting
Edit Points
If the edit points are not set correctly, for example if an
OUT point is before a corresponding IN point, the
DELETE button flashes, and it is not possible to carry
out a preview or editing operation. In this case, either
modify the erroneous edit point, or first delete it and
then enter it correctly.
Modifying an edit point
To modify an edit point, use the following procedure.
Time data display area 1
Time data display area 2
3
1
Press the RECORDER button or PLAYER button
to select the VTR on which you wish to modify the
edit point.
The button you have pressed lights.
2
Hold down the IN button or OUT button according
to the edit point you wish to modify, and turn the
search dial as follows:
• To advance the edit point: the FORWARD
direction
• To delay the edit point: the REVERSE direction
The time value for the IN or OUT point displayed
in time data display area 1 or 2 increases or
decreases according to the direction in which you
turn the search dial.
3
When the modification is completed, release the
button you pressed in step 2.
1 2