Convert Mode 2 To Mode 1 - GREAT PLANES RealFlight 7 User Manual

Throttle

Convert Mode 2 to Mode 1

The RealFlight InterLink Elite is primarily offered in the Mode 2 configuration. If you
wish to convert your InterLink controller to Mode 1 for use with RealFlight, please
following these directions.
Tools Required-
• Medium Phillips-head screwdriver
• Hemostats (preferred), or needle nose pliers
Instructions-
Please read all instruction carefully before you begin this conversion. Great Planes will
not accept responsibility for incidental damage to your InterLink controller or personal
computer as a result of failure to adhering to these instructions properly. Please
control Software Support prior to performing this conversion if you have any
questions about this procedure.
1. Make sure your InterLink Elite controller is completely disconnected from
your computer. Failure to do so could result in permanent damage to your
InterLink Elite controller and/or your computer.
2. Remove the four screws from the rear of the controller, remove the case rear
half, and lay the controller face-down on your workspace.
Rudder Elevator
347
Aileron