GREAT PLANES RealFlight 7 User Manual page 286

A welcome dialog will appear to explain the goals of this trainer and offer a few tips. If
you do not wish to see this dialog screen again each time you load this trainer, simply
click the Don't show this message again checkbox at the bottom, then click Close.
Following the welcome dialog, the get ready dialog screen will appear. This screen will
explain what you are required to do for this trainer. There is also a checklist that you
should follow before you proceed. If an item in the checklist is properly adjusted, the
Ready light will illuminate. Otherwise, the Ready light will be dim, and the function on
the controller pictured to the left will blink indicating what needs to be done.
The get ready dialog is a great way to prepare for the trainer. Once you have
successfully run through the trainer a few times and no longer wish to see this dialog,
simply click the checkbox labeled Don't show this message again and then click Go.
Once you are running the trainer, you'll notice a circle on the ground. This circle
represents the training boundary. If your airplane ventures beyond this boundary, it
will break apart and the session will begin once again. You'll also note an 'X' mark
within the boundary that represents the current location of your airplane. The goal is
to control the airplane in a stable hover; keeping it as close to the center of the circle as
possible.
282