idp Smart-30 Technical Manual page 91

Status codes are changed after Printer firmware 1.00.60 as below.
SMSC_S_CLEANWARNING
SMSC_S_THUP
SMSC_S_EQUIPLAMINATOR
SMSC_S_ROTATORTOP
2014-03-24
0x0000000000080000 // Need to cleaning State (After f/w
0x0000000000080000 // Thermal Print Head Up state (Before f/w 1.00.60)
0x0000000000400000 // Laminator is installed (After f/w 1.00.60)
0x0000000000400000 // Card Front Side is up at Rotator (Before f/w 1.00.60)
4.2 Test
1.00.60)
91