Printer Setup Adjustment; Printing Location - idp Smart-30 Technical Manual

4.1.3 Printer Setup Adjustment

4.1.3.1 Printing Location

SMART Card Printer is the direct thermal printer and need to some
setting to print all over the card surface.
In CardPrinterSetup, if press "Print" button, the image like left side will
be printed. In this time, if four circles on each side are printed well
and the space of upper & bottom is in 0.5mm, it is proper setting.
For correct setting, you can adjust the setup value as follows.
1. Do not make too much space on left and right side as adjusting X
start position value.
2. Do make the image start point in 0.4mm ~ 0.5mm from the card
upper side as adjusting Y start position value.
3. Do make the image end point in 0.4mm ~ 0.5mm from the card
bottom side as adjusting Y end position value. In this case, Y scale
value should be input more bigger than the proper setup value.
4. Do make the four circles can be shown fully as adjusting Y scale value.
2014-03-24
4.1 Setup
55