idp Smart-30 Technical Manual page 14

No Watchman LED
Check Please.. RED
8
Blink
Ribbon Not Found
Check Please.. RED
9
Blink
Ribbon Zero
Check Please.. RED
10
Blink
TPH Not Found
Card Out Error RED
11
Blink
< Cancel >
Board Test Mode RED
12
Blink
Wait
2014-03-24
State
Button
Ribbon Ribbon is not installed or
Research not searched
Ribbon
All ribbons are used
Research
Thermal Print Head is
not installed
Card Out Error
Initializing
(Check card in Printer)
Printer Test Mode
Fail to ribbon search. Check the ribbon installed status and if there is nor ribbon,
please reinstall ribbon in printer.
Ribbon remains is zero. Need to change the ribbon. If pressing button, SMART-
30 search ribbon again.
When the thermal Print Heat is not installed or disconnected to head cable, this
message is displayed. Please power off SMART printer and check the thermal
head installation status.
When there is printing error , the card is not ejected after pressing button.
SMART-30 is on test mode that the sensors and motors of printer are tested.
1.1 Printer Basic Information
상세 설명
14