Contactless Encoder Option Wiring - idp Smart-30 Technical Manual

CONTACTLESS ENCODER Option Wiring


PCBA USB
HUB
PORT 2
2014-03-24
PORT 3
M / B
1. Wire of Contactless Encoder is located on
the upper side of USB Hub on Printer
Main Board. Connect the wire of
Contactless Encoder to USB port
Orange
2. At this time, the wire of Contactless
Encoder must be connected to
PORT3.
* For assembling USB HUB on
Printer Main Board, refer to C.5.
* For assembling ETHERNET
Option, refer to C.6
PCBA INTERNAL
RF OPTION PART
C.4 Internal RF Option
(-
Line).
PORT2 or
182 182