Wall Bracket Mounting Instructions - Pyramid TIMETRAX BIO Reference Manual

WALL BRACKET MOUNTING INSTRUCTIONS

Wall Bracket Kit Includes the Following:
• (1) Stainless Steel bracket
• (1) Sheet metal screw size #6 x 1/2"
(Terminal to Bracket)
• (2) Sheet metal screws size #10 x 1"
(Bracket to Wall)
• (2) Wall anchors
Tools Needed:
• A drill equipped with a standard
3/16" drill bit
• A hammer to drive the anchor into
the wall after the holes are drilled
• A #2 Phillips screwdriver
• A ruler or tape measure
Installation Steps:
Locate which wall you wish to mount your
terminal to. You will need a 110-volt wall
power outlet close to your terminal. For best
usability, Pyramid suggests mounting the
bracket 40" from the floor. We also suggest
securing at least (1) of the supplied screws to
a stud within the wall. Use your bracket for
proper hole guidance. Now mark your hole
locations. Drill (2) 3/16" holes into the wall
where marked. Insert the wall anchors into
the holes, and use your hammer to drive in
both of the anchors flush with the wall.
Now lineup your terminal bracket with the
anchors and use the (2) supplied #10 x 1"
screws and fasten the bracket to the wall.
Make sure not to over tighten the screws.
At this point you can place the TimeTrax
Bio terminal onto the wall bracket. Pull the
terminal towards the front of the bracket
and align the single hole on the center of
the bracket with the single hole on the
center of the terminal. Take the supplied
#6 x 1/2" screw and securely fasten the
terminal to the wall bracket.
NOTE: Damage to the terminal due to
over tightening to the wall bracket will
not be covered by your warranty. Make
sure not to over tighten the screw.
TIME & ATTENDANCE SYSTEM
At this point your TimeTrax Bio
terminal and bracket should be fully
secured to the wall. You can go ahead
and hardwire the terminal to your
desired central PC with the supplied
cables. For a clean installation, run
your wires through the 3/4" hole
on the backside of the wall bracket.
If you have any further wall
mounting or terminal hookup
questions, please come visit us at
www.pyramidtechnologies.com, or
simply call (888) 479-7264.
49