TIMETRAX™ SYNC PoE DIGITAL CLOCK Installation Instructions OVERVIEW Thank you for choosing a TimeTrax™ Sync PoE Clock System. The TimeTrax™ PoE Clock System is capable of receiving both its time and power from a cost-effective and reliable Power over Ethernet source. The POE Analog Clock may be powered by the Ethernet (see PoE Switch Method-pg.
Page 2
TIMETRAX™ SYNC PoE DIGITAL CLOCK Installation Instructions (cont.) PoE SWITCH METHOD Connect CAT-5E Ethernet cable (sold separately) into RJ-45 Ethernet port located on back of clock. If using standard electrical box mounting method, please advance to step 3. If not using electrical box, hold security bracket flush against wall, level & mark four screw holes close to corner tabs.
Page 3
TIMETRAX™ SYNC PoE DIGITAL CLOCK Installation Instructions (cont.) NON-PoE SWITCH METHOD Connect CAT-5E Ethernet cable (sold separately) into Ethernet RJ-45 port located on back of clock. If using standard electrical box mounting method, please advance to step 3. If not using electrical box, hold security bracket flush against wall, level & mark four screw holes close to corner tabs.
TIMETRAX™ SYNC PoE DIGITAL CLOCK Installation Instructions (cont.) SPECIFICATIONS Microprocessor Time Base Time Update Configurable ( 1/minute – 1/week) Frequency Method NTP time server ETHERNET RJ 45 CORD Power Input 48VDC 105-120 VAC Average Power 4.848 Watts 5.6 Watts Consumption Operating Temp -30°F (-34.44°C) to 130°F (54.44°C) Warranty...
Failure caused by accident, alteration, misuse or improper packaging of returned unit is not covered by this Warranty. Any repair to equipment other than by Pyramid voids the Warranty. Users in territories other than USA, Canada, South America & Australia should contact the Dealer from whom the unit was purchased. The rights under this Warranty are limited to original user and may not be transferred to subsequent users.