Table of Contents
Advertisement
TIMETRAX BIO
Using the Fingerprint Scanner
The following fingerprint scanning procedure is used for both Fingerprint
Registration and regular use.
It is recommended that you use the index finger or middle finger for
enrollment and the same finger needs to be used for punching in and out.
It is very important that the fingerprint captured during enrollment is
consistent with the fingerprint that will be scanned on a daily basis.
Swiping on an angle, twisting the finger during the swipe or any other
abnormal motion may cause fingerprint recognition problems during
normal daily operations.
For Optimum Fingerprint Quality, before swiping, make sure the finger is:
• Clean and free of debris
• For employees with dry fingers, apply a light coating of moisturizer
• For employees with moist or oily fingers, wipe dry using a clean,
dry cloth
Place your fingertip on the top of the sensor module (A), then applying
light pressure, swipe your finger downward on the sensor in one smooth
motion (B). (See illustration on page 5)
When enrolling, the terminal will display SWIPE 1 OF 2. At this prompt,
swipe the first time. Terminal will display SWIPE 2 OF 2, asking the user
to duplicate the swipe just completed. During normal operation, the user
will only need to swipe one time to log a punch.
If an error should occur, the terminal may display TRY AGAIN. This
indicates that the swipe was not accepted and needs to be done again.
During normal punching in and out, the time recorder will beep and the
Employees name and ID number will display briefly on the LCD screen.
4
Hide quick links:
Advertisement
Table of Contents
