Figure 2.10 Unit Installation Area; Table 2.3 Specifications For The Unit Installation Area - Fujitsu ETERNUS DX500 S3 Site Planning Manual

Chapter 2 Rack Installation Specifications
2.2 Installable Racks

Figure 2.10 Unit Installation Area

Front door of the rack

Table 2.3 Specifications for the Unit Installation Area

Specification
(1) Rack front space
(Space between the fixed part of the ETERNUS DX
on the front side and the front of the rack)
(2) Mount bracket length
(Size between each end of the front and rear rack
pillars)
(3) Rack space
(Space between the fixed part of the ETERNUS DX
on the front side and the rear of the rack)
(4) Rack mount kit installation area
■
Placement Requirements
When determining service areas, refer to the manual of the rack that is to be used.
Make sure to perform the installation according to the placement requirements described in
Specifications" (page 11)
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
(1) (2)
(3)
ETERNUS DX
(4)
Rack pillars
and "1.6 Installation Environment" (page
49
Copyright 2014 FUJITSU LIMITED
Rack rails
Rear door of the rack
Conditions when high-density drive
Condition
enclosures are installed
40mm or more 80mm or more
685mm or more 685mm or more
775mm or less 750mm or less
890mm or more 915mm or more
482mm or more 490mm or more
(recommended)
24).
"1.1 Installation
P3AM-7712-05ENZ0