Fujitsu ETERNUS DX500 S3 Site Planning Manual page 14

Chapter 1 ETERNUS DX Installation
1.1 Installation Specifications
Item
Maximum
amount of ex-
haust air
Environmental
conditions
Vibration limit
Noise emission
(*3)
*1: A 2U power distribution unit is composed of two 1U power distribution units.
*2: These values are for each drive enclosure when 24 drives are installed in a 2.5" type drive enclosure, 12
drives are installed in a 3.5" type drive enclosure, or 60 drives are installed in a high-density drive en-
closure.
*3: These values are measured when a single controller enclosure and four drive enclosures are configured
in an environment in which the temperature is 23 ± 2 °C.
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Site Planning Guide
Controller enclosure
Drive enclosure (*3)
Temperature
Temperature gradient
Humidity
Humidity gradient
Maximum wet bulb temperature
Altitude above sea level
Airborne dust
Gas concentration tolerance level
Oil vapor
Seawater (salt corrosion)
Operating
Not operating
Sound Pressure Level
Sound Power Level
Copyright 2014 FUJITSU LIMITED
ETERNUS DX600 S3
3
6.2m /min
2.5" type 3
4.0m /min
3.5" type
3
4.0m /min
High-density 3
12.0m
type
Operating 10 – 40°C
Not operating 0 – 50°C
Shipping -40 – 60°C
15°C/Hr or less
Operating 20 – 80%RH
Not operating 8 – 80%RH
Shipping 8 – 90%RH
30%/day or less
29°C
0 – 3000m
0.15mg/m
Cl : 3.4ppb or less, H
2
SO : 37ppb or less, NH
2
NO : 52ppb or less, O
2
HCl: 6.6ppb or less, HF: 3.6ppb or less
0.2mg/m
If the ETERNUS DX is installed on the ocean or
premises within 0.5km from the coast, necessary
measures must be taken to prevent salt corro-
sion.
400gal
1,000gal
54dB (A)
7.2B
14
/min
3
or less
S: 7.1ppb or less,
2
: 420ppb or less,
3
: 5ppb or less,
3
3
or less
P3AM-7712-05ENZ0