lower value of the smoothing, the higher quality of the stream, though it may
appear not fluent.
4. Click Save to save the settings.
6.4.2 Configuring Audio Settings
Steps:
1. Enter the Audio Settings interface
Configuration > Basic Configuration > Video / Audio > Audio
Or Configuration > Advanced Configuration > Video / Audio > Audio
2. Configure the following settings.
Note:
Audio settings vary according to different camera models.
Audio Encoding: G.722.1, G.711 ulaw, G.711alaw, G.726, MP2L2 and PCM are
selectable. For MP2L2, the sampling rate and audio stream bitrate are
configurable; for PCM, the sampling rate can be set.
Audio Input: MicIn and LineIn are selectable for the connected microphone and
pickup respectively.
Input Volume: 0-100
Environmental Noise Filter: Set it as OFF or ON. When you set the function on
the noise detected can be filtered.
Note:
When the sampling rate is greater than 32kHz, the environmental noise
filter function is invalid.
3. Click Save to save the settings.
User Manual of Network Camera
Figure 6-30 Audio Settings
61