Configuring Video Tampering Alarm - HIKVISION Network Camera User Manual

(3)Select the start time and the end time for the switch timing.
(4)Select the area by clicking the area No.
(5)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area in the daytime.
(6)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area at night.
(7)Set the arming schedule and linkage method as in the normal configuration
mode.
(8)Click Save to save the settings.

6.6.2 Configuring Video Tampering Alarm

Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
some certain alarm response actions.
Steps:
1. Enter the video tampering Settings interface:
Configuration > Advanced Configuration > Basic Event > Video Tampering
2. Check Enable Video Tampering checkbox to enable the video tampering
detection.
User Manual of Network Camera
Figure 6-51 Video Tampering Alarm
82