HIKVISION Network Camera User Manual page 101

Configuration> Advanced Configuration> Smart Event> Loitering Detection
2. Check the checkbox of Enable Loitering Detection to enable the function.
3. Select the region from the drop-down list for detection settings.
4. Click the Draw Area button to start the region drawing.
5. Click on the live video to specify the four vertexes of the detection region, and
right click to complete drawing.
6. Set the time threshold and detection sensitivity for loitering detection.
Threshold: Range [0s-10s], the threshold for the time of the object loitering in
the region. If you set the value as 5, alarm is triggered after the object loitering in
the region for 5s; If you set the value as 0, alarm is triggered immediately after
the object entering the region.
Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the
object which can trigger the alarm. When the sensitivity is high, a very small
object loitering in the region can trigger the alarm.
7. Repeat the above steps to configure other regions. Up to 4 regions can be set. You
can click the Clear button to clear all pre-defined regions.
8. Click the Edit button to set the arming schedule.
9. Select the linkage methods for loitering detection, including Notify Surveillance
Center, Send Email, Upload to FTP, Trigger Channel and Trigger Alarm Output.
10. Click Save to save the settings.
User Manual of Network Camera
100