Installing Dimms - HP ProLiant BL40p Setup And Installation Manual
Server blade
Hide thumbs
Also See for ProLiant BL40p:
- Maintenance and service manual (85 pages) ,
- Troubleshooting manual (152 pages) ,
- Overview (48 pages)
Table of Contents
Advertisement
Installing DIMMs
Before installing DIMMs, review "Online Spare Memory Configuration" in this
chapter.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure. Refer to Appendix B,
"Electrostatic Discharge," for more information.
To install a DIMM:
NOTE: The server blade ships with at least two DIMMs installed in DIMM slots 1A and 2A.
1. Remove the access panel. Refer to "Preparation Procedures" in this chapter.
2. Open the DIMM slot latches.
3. Align the key slot in the bottom edge of the DIMM with the tab in the DIMM
slot.
IMPORTANT: DIMMs do not seat if turned the wrong way.
HP ProLiant BL40p Server Blade Setup and Installation Guide
Installing the Server Blade and Options
1-19
Advertisement
Table of Contents
