Processors - HP ProLiant BL40p Setup And Installation Manual
Server blade
Hide thumbs
Also See for ProLiant BL40p:
- Maintenance and service manual (85 pages) ,
- Troubleshooting manual (152 pages) ,
- Overview (48 pages)
Table of Contents
Advertisement
Processors
The ProLiant BL40p server blade has the capability of up to four Intel® Xeon™
processors. To remove a processor:
1. Power down the server blade and remove it from the server blade enclosure.
Refer to "Preparation Procedures" in this chapter.
2. Remove the access panel and the system board tray. Refer to "Preparation
Procedures" in this chapter.
3. Unsnap the SCSI I2C cable and SCSI backplane power cable from the processor
baffle.
4. Slide the processor baffle back, and lift it off of the processor assemblies. Push
the cables through the access holes in the processor baffle, but leave them
attached to the system board as the processor baffle is removed.
CAUTION: To avoid damaging the system board, use caution when removing the
processor baffle. The SCSI I2C cable must remain attached to the system board at
this point.
Figure 1-15: Removing the processor baffle
HP ProLiant BL40p Server Blade Setup and Installation Guide
Installing the Server Blade and Options
1-21
Advertisement
Table of Contents
