Table of Contents
Advertisement
The MVME2603/2604 base board supplies a
to the 14-pin combined LED-mezzanine/remote-reset connector,
J1. When J1 is used as a remote reset connector with the LED
mezzanine removed, the
external speaker. For the pin assignments of J1, refer to
On the MVME2603/2604 base board, the standard serial console
port (
) serves as the PPCBug debugger console port. The
COM1
firmware console should be set up as follows:
Eight bits per character
One stop bit per character
Parity disabled (no parity)
Baud rate of 9600 baud
9600 baud is the power-up default for serial ports on MVME2603/
2604 boards. After power-up you can reconfigure the baud rate if
you wish, using the PPCBug PF (Port Format) command via the
command line interface. Whatever the baud rate, some type of
hardware handshaking Ñ either XON/OFF or via the RTS/CTS
line Ñ is desirable if the system supports it.
Hardware Preparation and Installation
SPEAKER_OUT
signal can be cabled to an
SPEAKER_OUT
1
signal
Table
4-1.
1-53
Hide quick links:
Advertisement
Table of Contents
