Figure 1-18. Ram200 Placement On Mvme2603/2604 - Motorola MVME2603-1121A Installation And Use Manual

4. Place the RAM200 mezzanine module on top of the base
board. Connector J9 on the underside of the RAM200 should
connect smoothly with the corresponding connector J7 on the
MVME2603/2604.

Figure 1-18. RAM200 Placement on MVME2603/2604

5. Insert the four short Phillips screws through the holes at the
corners of the RAM200, into the standoffs on the
MVME2603/2604. Tighten the screws.
6. Reinstall the MVME2603/2604 assembly in its proper card
slot. Be sure the module is well seated in the backplane
connectors. Do not damage or bend connector pins.
7. Replace the chassis or system cover(s), reconnect the system
to the AC or DC power source, and turn the equipment
power on.
Hardware Preparation and Installation
1
11661.00 9611 (2-3)
1-37