Clickshare Installation; Installation Methods For The Base Unit - Barco ClickShare Installation Manual

4. CLICKSHARE INSTALLATION

About this chapter
The installation chapter gives an overview of the different ways to install the base unit of ClickShare, the possible connections and
the use of ClickShare Link for an iPad connection.
Overview
•

Installation methods for the Base unit

• Table mounting
• Wall mounting
• Ceiling mounting
• Rack mounting
• Recommendations about antenna placement and orientation
• Video signal connections to the Base Unit
• Audio connection
• LAN connection
• Power connection and switching on
• Connecting an iOS device
• About Network integration
W
ARNING
W
ARNING
C
AUTION
vertical according to the installation instructions.
W
ARNING
W
ARNING
local dealer for a correct power cord.
4.1 Installation methods for the Base unit
For optimal performance, install the Base Unit close to the display and avoid obstacles between the Base Unit
and the Buttons. Do not block the fan inlets and outlets of the Base Unit!
Introduction to the installation methods
The base unit can be installed in different ways in a meeting room:
• Table mounted
• Wall mounted
• Ceiling mounted
• Rack mounted
R5900004 CLICKSHARE 23/12/2014
:
Do not connect to the mains power during installation.
:
Make sure the mains power connection to the Base Unit is accessible to the user at all times.
:
Mounting the Base Unit under a random angle is not allowed. It should be mounted horizontal or
:
Only use the antennas that are delivered with the product. Other antennas are not allowed.
:
Use a power cord which complies to local regulations. If not included in the box, contact your
4. ClickShare installation
17