Transmitting An Sdm - Icom IC-F5060 Series Operating Manual

2
BIIS 1200 OPERATION

■ Transmitting an SDM

D General
The short data message, SDM, can be sent to an individual
station or group stations. Also, 8 SDM memory channels are
selectable and the messages can be edited on your PC.
D Transmitting an SDM
q While in the standby mode, push [BIIS Button], then push
[CH Up] or [CH Down] to select the desired station/group
code.
w Push [BIIS Button] again, then push [CH Up] or
[CH Down] to select the desired SDM.
• " " appears.
M E S S A G E
S D M
e Push [Call] or [PTT]* to transmit the SDM to the selected
station/group.
* A PTT call can be made only when PTT call capability is permit-
ted.
• 2 beeps sound and the transceiver automatically returns to the
standby mode when transmission is successful.
11
Appears
1
1
SDM is displayed.
D Direct message input
The optional HM-152T is required for this operation.
q While in the standby mode, push [BIIS Button] twice, then
push [CH Up] or [CH Down] to select the desired SDM to
be edited.
• " " appears.
w Push [M] or [#] to enter the message editing mode.
• The first character blinks when [#] is pushed; the last character
blinks when [M] is pushed.
• " " blinks.
e Push the appropriate digit key, [0] to [9], to enter the de-
sired character.
• See the table on page 12 for the selectable characters.
• Pushing [CH Up] also enters a space, pushing [CH Down] de-
letes the selected character.
r Push [#] to move the cursor to the right, push [M] to move
the cursor to the left.
t Repeat steps e and r to enter the desired text mes-
sage.
y Push and hold [BIIS Button] for 1 second to write the set
message into the message memory.
• Push [BIIS Button] momentarily to cancel the editing and return
to the original message display.