Icom IC-F5060 Series Operating Manual page 21

D Receiving a Message
q When a Message is received:
• Beeps sound.
• The calling station ID (or alias) and the message are alternately
displayed.
I D 1 2 3 4
M S G 1
w Turn power OFF, push [PTT], or change the channel to
stop the display indication.
D Receiving a Status Message
➥ When a Status Message is
• Beeps sound.
• The calling station ID (or alias) and the status message are dis-
played once.
I D 1 2 3 4
S T A T U S 1
received:
MDC 1200 SYSTEM OPERATION
D Receiving a Stun or Revive
If a Stun command is received that matches your station
ID, the transceiver will display "SORRY" and you can not re-
ceive or transmit. When a Revive command is received that
matches your station ID, normal operation is restored.
D Call log function
After receiving the SelCall, Call Alert and Emergency call,
the call logs may be displayed, depending on the presetting.
Up to 5 logs can be memorized, and the oldest log is erased
when a 6th call is received.
q Push [MDC Call] to enter the MDC menu selection mode.
w Push [CH Up] or [CH Down] to select "CALL LOG".
e Push [MDC Call] again to display the call logs.
• When no call is received, an error beep sounds.
Calling station ID
I D 1 2 3 4
S C -
Call type
: SelCall
SC
: Call Alert
CA
: Emergency call
EMG
r Push [CH Up] or [CH Down] to select the desired call log
memory.
NOTE: After 1000 hours has passed from when the call
was received, the elapsed time resets to 0:00.
3
0 : 2 7
Elapsed time after
receiving the call
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18