Table of Contents
Advertisement
Installation
This chapter describes how to install and configure the HP 10:10 LAN Bridge MB, and verify
that it is operating correctly.
Installation Summary
The steps to install the HP 10:10 LAN Bridge MB are:
1. Mount the bridge (in a rack, on a wall, or on a table).
2. Connect the bridge to the networks.
3. Plug in the bridge and verify its operation.
4. Customize the bridge's configuration if necessary (for example, because you want to
enter static addresses into the bridge's address table, or because the bridge will be
managed remotely from a network management station on an IP network).
The details for these steps are provided in the rest of this chapter.
Tools and equipment needed for mounting the bridge in a rack or on the wall:
Phillips (cross-head) number 1 screwdriver (for rack or wall mounting)
⁄
5
four
-inch number 12 wood screws or equivalent (for wall mounting only)
8
2
Installation 2-1
Advertisement
Table of Contents
