HP 10:10 LAN Bridge MB Installation And Reference Manual page 17

For Rack or Cabinet Mounting:
1. Using a Phillips or cross-head screwdriver, attach the mounting brackets to the bridge
with 10-mm M4 screws (included in accessory kit). Note that the bridge's case and the
mounting brackets are designed to allow you to rack mount the bridge with either the
back or the front facing out.
2. Position the bridge in the rack or cabinet and slide it up or down until the rack holes line
up with the bracket holes. Then attach the bridge to the rack with
12-24 screws (included in the accessory kit). (Some cabinets require number 10-32
screws instead, available as p/n 2680-0302. Make sure you have screws that fit your
cabinet or rack before mounting the bridge.)
Front facing out
10-mm M4 screws
Back facing out
Mounting bracket
⁄
5
-inch number
8
12-24 screws
Mounting bracket
⁄
5
-inch number
8
Installation 2-3