Configuration - HP 10:10 LAN Bridge MB Installation And Reference Manual

Configuration

Use the information in this chapter only if you wish to customize the bridge configuration. The
bridge is pre-configured with default values that are designed to work well for most
installations. With the default configuration, the bridge functions as a learning bridge that does
not support the Spanning Tree Protocol.
These configuration changes can be made through the bridge's console interface:
Static addresses can be added to or deleted from the address table (ADdress table
command).
An Internet Protocol (IP) address can be assigned to the bridge so it can be managed
remotely from a network management station over a TCP/IP network (IPconfig
command).
The bridge operating state can be changed (OPerating state command ).
Up to two wildcard filters can be added, deleted, and changed (WIldcard command).
See "Configuration Commands" in this chapter for details on these commands. See "Starting a
Console Session" on the next page for the procedures to access and use the bride's console
interface.
(The bridge can also be configured over the network from an HP network management station.
See the network management product documentation for more information.)
3
Configuration 3-1