HP 10:10 LAN Bridge MB Installation And Reference Manual page 31

Table of Contents

Advertisement

IP Configuration Parameters:
IP Address
Subnet Mask
Primary Default Router
Backup Default Router
Time To Live
See your network administrator for these IP settings. For information on setting the IP address,
see appendix D "Network Addressing".
The IP address of the bridge, written in the format X.X.X.X.
Each number between the decimal points is a decimal number
between 0 and 255. Use from 1 to 254 in the fourth position.
0 and 255 are reserved values. Every IP address on a network
must be unique. The default is 0.0.0.0, which disables IP
communications on the bridge.
The bit mask defining which portion of the IP address is the subnet
address, written in the format X.X.X.X. A default value is
automatically generated and depends on the class of IP address that
you entered. See your network administrator for the subnet mask
used by all devices on your IP network.
The IP address of the nearest IP router in your network. The
default value is 0.0.0.0. If no IP routers are in your network, enter
the address of a network management station, if any.
The IP address of the router used in place of the primary default
router when it is inaccessible. The default value is 0.0.0.0. If there
is no backup router, or no primary default router, use 0.0.0.0.
The number of IP routers a packet is allowed to cross before the
packet is discarded. The default value is 32. Increase this value if
the bridge will be sending IP packets to a destination that is more
than 32 routers away. The maximum is 255.
Configuration 3-7

Advertisement

Table of Contents
loading

Table of Contents