HP 10:10 LAN Bridge MB Installation And Reference Manual page 38

COnfig
Starts Config Mode for customizing the bridge configuration. (See "Config Mode Commands"
later in this chapter.)
DIsconnect
Terminates the console session and resets the console port to automatically sense the console
baud rate. If the console is connected to the bridge through modems, this command causes the
modems to disconnect (hang up).
PAssword
Prompts you to enter or change the bridge access password. By default, there is no password.
The password is used to prevent unauthorized access of the bridge from network management
stations and through the bridge's console interface.
Once you set a password, you will be prompted for it each time you start a bridge console
session and each time you use an HP network management product to change the bridge
configuration. The same password is used for both applications.
You can delete the password by changing it to a null string, (just press RETURN at the
password prompts without entering any characters.)
Make sure you record the password in a secure place. If you forget the password, you must
press the button labeled Clear on the back of the bridge . See "Clearing the Bridge Password"
later in this chapter.
4-4 Operation