Table of Contents
Advertisement
This chapter describes the procedures used for installing a Universal Port Module
(UPM) kit into a Director 2/64 or a Director 2/140. For each UPM kit to be installed,
perform the following procedures to:
•
Remove the UPM filler blank
•
Install the UPM
Supported Kits
HP sells the StorageWorks Director 2/64 with a base configuration of 32 Fibre Channel
ports and the StorageWorks Director 2/140 with a base configuration of 64 Fibre
Channel ports. HP also sells optional kits to increase the number of ports to a
maximum of 64 for the Director 2/64 and a maximum of 140 for the Director 2/140.
Use the procedures described in this chapter for the following director UPM kits:
•
8-Port UPM Kit, 300833-B21 (A6574B)
— (2) Short-wave-4-Port cards, includes (8) short-wave 2 Gbps SFP optical
transceivers
— (1) Loop back plug (multi-mode/short wave)
— (1) Port card installation instructions
— (1) Warranty
•
4-Port UPM Kit, 286808-B21
— (1) Short-wave-4-Port card, includes (4) short-wave 2 Gbps SFP optical
transceivers
— (1) Loop back plug (multi-mode/short wave)
— (1) Port card installation instructions
— (1) Warranty
universal port module kit installation instructions
Installation Instructions
1
Advertisement
Table of Contents
